Mindray DPM 1 Manuel de l'opérateur télécharger pdf (Page 55)

5-5

WARNING

 If alarm tones are switched off, the monitor does not give audible alarm signal

even if new alarms occur. So take care when you switch off alarm tones.

5.3.2 Physiological Alarm Off

If alarms related to a parameter are switched off, the monitor does not generate alarms even

if the measured parameter values exceed the alarm limit. This status is called Alarms Off.

To disable the alarms of a parameter, you need to open SET ALARMS menu .Take NIBP

(Non-Invasive Blood Pressure) as an example.

1. Press

to open the SET ALARMS menu.

2. Move the cursor to the pane to the right of SYS ALM.

3. Select OFF and the NIBP alarms are disabled.

NOTE

 Within 30s after the NIBP, SPO2 and TEMP modules are loaded, physiological

and technical alarms related to these modules are switched off automatically.

5.3.3 Alarms Paused

Shortly pressing for less than 2 seconds can pause all alarms for 2 minutes. When

alarms are paused,

 Alarm lamp flashing and alarm tones are suspended.

 For a physiological alarm, alarm message is not displayed.

 For a technical alarm, alarm message is displayed if Alarm lamp flashing and alarm

tones can be cleared.

 For a technical alarm, alarm message is not displayed if all alarm indications can be

cleared completely.

 The remaining alarm pause time is shown at the right side fo alarm information area.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 119 120

Pas de commentaire

Mindray DPM 1 Manuel de l'opérateur Page 55