Mindray DPM 1 Manuel de l'opérateur télécharger pdf (Page 42)

4-2

NOTE

 The system automatically creates a patient ID each time the monitor is turned

on.

 Select appropriate patient type each time a patient is admitted.

 If you need to change patient type after the patient has been admitted, switch off

QUICK ADMIT; press

and then change PATIENT TYPE in the pop-up

PATIENT INFORMATION menu.

 If you need to admit a patient in the event both BARCODE POWER and

QUICK ADMIT are set to OFF, switch either of them on.

 By holding and pressing for at least one second when the PATIENT

INFORMATION menu is not opened, you can quickly switch the patient type.

In this case the patient ID will not be changed.

4.2 System Setup

By pressing on the front panel of the monitor, you can open the SYSTEM SETUP

menu as shown in Figure 4-2.

Figure 4-2

4.2.1 Common Setup

In the SYSTEM SETUP menu, select COMMON SETUP. In the COMMON SETUP menu,

you can set the following items.

 ALARM VOL MIN ALARM VOL to 10

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 119 120

Pas de commentaire

Mindray DPM 1 Manuel de l'opérateur Page 42