Mindray DPM 1 Manuel de l'opérateur télécharger pdf (Page 37)

3-7

3.1.6 Powering on the Monitor

After installing the monitor, please power on it in the following procedure:

1. Before using the monitor, please carry out corresponding safety inspection in

accordance with Section 3.2.1Inspection.

2. Press the Power Switch on the control panel. A beep will be heard.

3. The system starts self-test and the start-up screen will be displayed.

4. Several seconds later, the system finishes the self-test and displays the Normal screen.

5. Then you can operate the monitor through the control panel.

When AC mains is connected, the battery will be charged regardless the monitor is on or

off.

3.1.7 Powering off the Monitor

To power off the monitor, please follow the procedures below:

1. Confirm the patient monitoring is to be finished.

2. Disconnect the cables and sensors between the monitor and the patient.

3. Confirm whether to store or clear the patient monitoring data.

4. Press the Power switch and hold it for more than 2 seconds to power off the monitor.

3.2 Maintenance

WARNING

 Failure to implement a satisfactory maintenance schedule may cause undue

equipment failure and possible health hazards.

 The safety inspection before equipment disassembly or the servicing of the

equipment must be performed by professional servicing personnel. Otherwise,

equipment failure and possible health hazard may be caused.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 119 120

Pas de commentaire

Mindray DPM 1 Manuel de l'opérateur Page 37