Mindray DPM 1 Manuel de l'opérateur télécharger pdf (Page 28)

2-10

2.4 Battery

Rechargeable batteries can be used to supply power to the monitor where AC mains is

unavailable or whenever the power supply is interrupted. The battery is charged

automatically when the monitor is connected to AC mains till it is full. If the power supply

is lost during monitoring, the monitor can run on internal battery.

The battery indicator indicates the status of the battery.

 ON: The battery is being charged or the battery is fully charged.

 OFF: The battery is removed from the monitor, or the monitor is equipped with battery

but is not connected to AC mains and not turned on.

 Flashes: The monitor is powered by the internal battery.

The capacity of the internal battery is limited. When the battery capacity is too low, a high

level alarm is triggered and the “Battery too low” message is given in the technical alarms

area. At this moment, the AC mains shall be applied to the monitor; otherwise the monitor

will power off automatically before the battery is depleted.

For details about installation of the battery, refer to 3.1.5 Installation Method:Installing the

battery.

WARNING

 Keep the battery out of the reach of children.

 Use only the battery specified by the manufacturer.

NOTE

 Remove the battery before transport, or if the monitor is not likely to be used

for an extended period of time.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 119 120

Pas de commentaire

Mindray DPM 1 Manuel de l'opérateur Page 28