Mindray DPM 1 Manuel de l'opérateur télécharger pdf (Page 53)

4-13

Output Procedure

1. Disconnect all patient cables connected to the monitor.

2. Verify the monitor is connected to the PC and the PC is running the Patient Information

Recall System software.

3. Select from the data source options.

4. Select OUTPUT in the menu and the prompt “CONNECTING…” is shown aside. If you

exit the DATA OUTPUT menu at this time, the prompt will be displayed in prompt

information area at the lower left corner of the screen.

5. If the connection is available, the data will be output to the PC. For more information, please

refer to the help information of the Patient Information Recall System software.

NOTE

z If no data source is selected or the previous data output has not finished, the

OUTPUT option in the DATA OUTPUT menu will be inactive.

4.4.6 Analog Output

Select ANALOG >> in SYSTEM SETUP menu. The following menu appears.

Figure 4-12 Analog Output

You can perform the following settings in the menu above:

 ANALOG OUT

Analog output

Options: ON and OFF.

When ON is selected, analog signals can be output from

the auxiliary output port on the rear panel of the monitor.

 ANALOG WAVE

Options: ECG1, ECG2, IBP1 and IBP2;

In the MULTI-LEADS DISPLAY mode, the ECG3,

ECG4, ECG5 and ECG6 options are also available.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 273 274

Pas de commentaire

Mindray DPM 1 Manuel de l'opérateur Page 53