Mindray DPM 1 Manuel de l'opérateur télécharger pdf (Page 179)

14-11

1. HI: Determines the high scale. The reference scale changes when the high scale is changed.

2. LO: Determines the low scale. The reference scale changes when the low scale is changed.

3. VAL: Determines the reference scale and position. The high and low scales remain

unchanged when the reference scale is changed.

NOTE

z The high scale should not be smaller than the low scale; the low scale should not

be larger than the high scale.

z The waveform amplitude changes when the high and low scales are adjusted.

 EXPAND PRESSURE Selecting this option opens the following menu. You can

select the pressure to be measured by P1 and P2.

Options: SYS, MEAN, DIA (three pressures are all

measured); MEAN (only the mean pressure is measured).

Figure 14-8 IBP Pressure Setup Menu

 CONFIG >> You can select this option to access the IBP (1,2) CONFIG

menu, in which you may select FACTORY CONFIG or

USER CONFIG. After finishing your selection and exiting

the menu, the system pops up a dialog box asking for your

confirmation.

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 273 274

Pas de commentaire

Mindray DPM 1 Manuel de l'opérateur Page 179